Show Me/Tell Me Questions
Download pdf
Category B Combinations from 01/07/2008Show /Tell Question and Answer
Q1Show me....Show me how you would check that the directionindicators are working
.Answer...Applying the indicators or hazard warning switchand check functioning of all indicators. (may needto switch ignition on, prompt not to start engine)
Q1 Tell me...Tell me how you would check that the brakes areworking before starting a journey
.Answer...Brakes should not feel spongy or slack. Brakesshould be tested as you set off. Vehicle should notpull to one side
.Q2 Tell Me...Identify where the windscreen washer reservoir isand tell me how you would check the windscreenwasher level.
Answer...Identify reservoir and explain how to check level
.Q2 Show me...Show me how you would check that the brakelights are working on this car. (I can assist you, ifyou need to switch the ignition on, please don'tstart the engine)
Answer...Operate brake pedal, make use of reflections inwindows, garage doors, etc, or ask someone tohelp. (may need to switch ignition on, prompt not tostart engine)
Q3 Show...Show me / explain how you would check that thepower assisted steering is working before starting ajourney.
Answer...If the steering becomes heavy the system may notbe working properly. Before starting a journey twosimple checks can be made. Gentle pressure onthe steering wheel, maintained while the engine isstarted, should result in a slight but noticeablemovement as the system begins to operate.Alternatively turning the steering wheel just aftermoving off will give an immediate indication that thepower assistance is functioning.
Q3 Tell me...Tell me where you would find the information forthe recommended tyre pressures for this car andhow tyre pressures should be checked.
Answer...Manufacturer's guide, use a reliable pressuregauge, check and adjust pressures when tyres arecold, don't forget spare tyre, remember to refitvalve caps.
Q4 Show me...Show me how you would check the parking brake(handbrake) for excessive wear, make sure youkeep safe control of the vehicle
Answer...Apply footbrake firmly. Demonstrate by applyingparking brake (handbrake) so that when it is fullyapplied it secures itself, and is not at the end of theworking travel.
Q4 Tell me...Identify where the windscreen washer reservoir isand tell me how you would check the windscreenwasher level
.Answer... Identify reservoir and explain how to check level.
Q5 Show me...Open the bonnet, identify where you would checkthe engine oil level and tell me how you wouldcheck that the engine has sufficient oil.
Answer...Identify dipstick / oil level indicator, describe checkof oil level against the minimum/maximum markers.
Q5 Tell me...Tell me where you would find the information forthe recommended tyre pressures for this car andhow tyre pressures should be checked.
Answer...Manufacturer's guide, use a reliable pressuregauge, check and adjust pressures when tyres arecold, don't forget spare tyre, remember to refitvalve caps.
Q6 Show me...Open the bonnet, identify where you would checkthe engine coolant level and tell me how you wouldcheck that the engine has the correct level.
Answer...Identify high/low level markings on header tankwhere fitted or radiator filler cap, and describe howto top up to correct level.
Q6 Tell me...Tell me how you make sure your head restraint iscorrectly adjusted so it provides the best protectionin the event of a crash
Answer...The head restraint should be adjusted so the rigidpart of the head restraint is at least as high as theeye or top of the ears, and as close to the back ofthe head as is comfortable. N.B. Some restraintsmight not be adjustable
Q7 Show me...Open the bonnet, identify where the brake fluidreservoir is and tell me how you would check thatyou have a safe level of hydraulic brake fluid.
Answer...Identify reservoir, check level against high/lowmarkings.
Q7 Tell me...Tell me how you would check the tyres to ensurethat they have sufficient tread depth and that theirgeneral condition is safe to use on the road.
Answer...No cuts and bulges, 1.6mm of tread depth acrossthe central ¾ of the breadth of the tyre and aroundthe entire outer circumference.
Back to top
Q8 Show me...Show me how you would check that the horn isworking (off road only).
Answer...Check is carried out by using control (turn onignition if necessary).
Q8 Tell me...Tell me how you would check the tyres to ensurethat they have sufficient tread depth and that theirgeneral condition is safe to use on the road.
Answer...No cuts and bulges, 1.6mm of tread depth acrossthe central ¾ of the breadth of the tyre and aroundthe entire outer circumference.
Q9 Tell me...Tell me how you would check that the brakes areworking before starting a journey.
Answer...Brakes should not feel spongy or slack. Brakesshould be tested as you set off. Vehicle should notpull to one side.
Q9 Show me...Show me how you would clean the windscreenusing the windscreen washer and wipers
Answer...Operate control to wash and wipe windscreen (turnignition on if necessary.
Q10 Tell me...Tell me how you would check that the headlights &tail lights are working. (No need to exit vehicle)
Answer...Explanation: Operate switch (turn on ignition ifnecessary), then walk round vehicle. (As this is a"Tell Me" question, there is no need to physicallycheck the lights.)
Q10 Show me...Show me how you would set the demister controlsto clear all the windows effectively, this shouldinclude both front and rear screens
Answer...Set all relevant controls including; fan, temperature,air direction / source and heated screen to clearwindscreen and windows. Engine does not have tobe started for this demonstration
Q11 Show me...Show me how you would switch on the rear foglight(s) and explain when you would use it/them.(No need to exit vehicle)
Answer...Operate switch (turn on dipped headlights andignition if necessary). Check warning light is on.Explain that they would be used when visibility is reduced to less than 100 metres.
Q11 Tell me...Tell me how you would know if there was aproblem with your anti lock braking system
Answer...Warning light should illuminate if there is a faultwith the anti lock braking system
Q12 Show me...Show me how you would check that the brakelights are working on this car. (I can assist you, ifyou need to switch the ignition on, please don'tstart the engine)
Answer...Operate brake pedal, make use of reflections inwindows, garage doors, etc, or ask someone tohelp. (may need to switch ignition on, prompt not tostart engine)
Q12 Tell me...Tell me how you would check that the headlights &tail lights are working. (No need to exit vehicle)
Answer...Explanation: Operate switch (turn on ignition ifnecessary), then walk round vehicle. (As this is a"Tell Me" question, there is no need to physicallycheck the lights.)
Q13 Show me...Show me how you switch your headlight fromdipped to main beam and explain how you wouldknow the main beam is on whilst inside the car
Answer...Operate switch (with ignition or engine on ifnecessary), check with main beam warning light
Q13 Tell me...Tell me how you would know if there was aproblem with your anti lock braking system
AnswerWarning light should illuminate if there is a fault
with the anti lock braking system
Download pdf
Back to top
Call us: 0191 5250562 / 07731 675 967 or e-mail gary@solouk.co.uk